Register
A password will be e-mailed to you.

Leica has released a minor firmware update for the M11 digital rangefinder camera. The update addresses a couple small bugs. As always, we recommend staying up to date on all firmware updates. Direct download link and installation instructions below.

Improvements

  • Fixed – Incorrect JPG tone curves in connection with some lenses, which caused the contrast in dark areas to be displayed too strongly.
  • Fixed – Non-coded lenses were displayed incorrectly in the user profiles.

Download M11 Firmware v1.5.0.1

To download the firmware file, simply click the button below. You'll need to drag and drop the downloaded firmware file onto an SD card which was freshly formatted in the M11, then insert the card into your Leica M11 with a fully charged battery. Navigate to the Camera Information menu to access the firmware update option. Don't try to open the firmware file on your computer – just copy it onto the SD card into the root directory.


 

Download Leica M11 Firmware v1.5.0.1


 

How to Update

EXECUTING A FIRMWARE UPGRADE

Any interruption of a running firmware update may cause serious and irreparable damage to your equipment!
You will therefore have to take particular note of the following, when carrying out a firmware update:

  • Do not switch off the camera!
  • Do not remove the memory card!
  • Do not remove the rechargeable battery!
  • Do not remove the lens!

Notes

  • A warning message will appear if the battery is insufficiently charged. Recharge the battery and then repeat the process described above.
  • You will find additional device and country-specific registration marks and numbers in the Camera Information submenu.

PREPARATION

  • Fully charge and insert the rechargeable battery
  • Any stored firmware files on the memory card must be removed
    • We recommend saving any images on the memory card and reformatting it before the update.
      (Caution: Loss of data! All data stored on the memory card will be lost during formatting.)
    • Make sure to back up any files saved to the internal memory as a precaution.
  • Download the latest firmware version
  • Save the download to the memory card
    • The firmware file must be stored in the main directory of the memory card (not in a sub-directory).
  • Insert the memory card into the camera
  • Switch the camera on

UPDATING THE CAMERA FIRMWARE

  • Preparation (see steps above)
  • Select Camera Information in the main menu
  • Select Camera Firmware Version
  • Select Firmware Update
    • A prompt with information about the camera is displayed.
  • Check the version information
  • Select Yes
    • The prompt: “Do you want to save profiles on SD card?” appears.
  • Select Yes/No
    • The update will start automatically.
    • The lower status LED will flash during this process.
    • Once the process has completed successfully, a relevant message will appear and the camera will restart.

Notes

  • Date & time, as well as the preferred language will have to be set up again after the restart. Relevant prompts will appear on screen.

Leave a Reply

Your email address will not be published.